Ejector sleeve hardened.
Hardened Ejector Sleeve with cylindrical head.
Range of application:
Injection moulding and die-casting. It is used in the manufacture of plastics and metal alloys with low melting point. Ejector sleeves take over the function of ejector.
The dimensions are shown in the table.
Material:
WS: Alloyed cold-work steel
Num. of material:
• 1.2516 (120 WV 4)
• 1.2067 (100 Cr 6)
Material properties:
Resistant up to 200 ° C / 392 ° F
Finish:
Hardened, Tempered, precision ground steel shank, sharpened leading hole, hot forged cylindrical head, non corrosive.
Note: Can be supplied with ejector pin upon request. Please quote when you order. Ejector pins are approximately 50 mm longer than the sleeves. Ejector sleeve, according to the inquiry is also available with the reduced point.