Ejector Pin with cylindrical head and reduced point.
Range of application:
Injection moulding and die-casting. Used in the manufacturing of plastics and metal alloys with low melting point. Flat ejector pins are used where the use of round ejector pins is not possible. The pin can be reduced to a minimum diameter of 0.50 mm. Particularly suitable for very small spray moldings.
The dimensions are shown in the table.
Material:
WS: Alloyed cold-work steel.
Num. of material:
• 1.2516 (120 WV4)
• 1.2067 (100 Cr 6)
Material properties:
Resistant up to 200 ° C / 392 ° F
Finish:
Hardened, tempered, precision ground shank and reduced point, hot forged cylindrical head, non corrosive.
Note: Ejector pins are also available with larger diameter shank and reduced point.