Ejector pins with cylindrical head and flat reduced point.
Range of application:
Injection moulding and die-casting. It is used in the manufacture of plastics and metal alloys with low melting point. Flat ejector pins are used where the use of round ejector pins are not possible.
Material:
WS: Alloyed cold-work steel
Num. of material:
• 1.2516 (120 WV 4)
• 1.2067 (100 Cr 6)
Material properties:
Resistant up to 200 ° C / 392 ° F
Finish:
Hardened, tempered, precision ground shank and reduced point, hot-forged cylinder head, non corrosive.
Also available with 4 x R 0,20 ali 2 x R 0,20 and DLC cover
Note: Other tolerances, quantities and sizes of radii
are available on request.